Sunepoxy SL Topcoat
SUNEPOXY SL TOPCOAT
SUNEPOXY SL TOPCOAT is three component pigment epoxy-based self-leveling floor topping consisting of a base, hardener, and quartz fillers supplied. It provides an aesthetic, smooth, monolithic, light reflective surface when laid on the floor.
ADVANTAGES
- Easy to apply.
- Flowable.
- Self-leveling, glossy.
- Excellent resistance to a wide range of chemicals.
- Excellent abrasion resistance.
- It provides a dense, impervious, seamless floor surface.
- Hygienic surface.
- Available in a wide range of colours to enhance the working environment.
- Nuclear grade.
TECHNICAL DATA
| Technical Parameters | Range/Value |
|---|---|
| Colour | Interpenetrating polymer network-based epoxy resin. |
| Shelf Life | 12 months in a tightly sealed container at 25°C. |
| Cleaning | Thinner. |
SIMPLE STEPS TO APPLY SUNEPXOY SL TOPCOAT
Pour The Material
The material should be poured onto the prepared and rimed substrate as soon as mixing is complete. It should be spread to the required thickness using a serrated trowel; with care taken not to overwork the resin, spreading evenly and slowly.
Roll The Material
Immediately after laying, the material should be rolled, using a spiked nylon roller, to remove slight trowel marks, and to assist air release. The rolling should be carried out using a 'back and forth' technique along the same path.
Overlap Of 50% Is Recommended
An overlap of 50% with adjacent paths is recommended. Further light rolling may be required to remove surface imperfections, or for subsequent release of trapped air, but should be done prior to the setting of the product.
SIMPLE STEPS TO APPLY SUNEPXOY SL TOPCOAT
Pour The Material
Roll The Material
The material should be poured onto the prepared and rimed substrate as soon as mixing is complete. It should be spread to the required thickness using a serrated trowel; with care taken not to overwork the resin, spreading evenly and slowly.
Immediately after laying, the material should be rolled, using a spiked nylon roller, to remove slight trowel marks, and to assist air release. The rolling should be carried out using a 'back and forth' technique along the same path.
Overlap Of 50% Is Recommended
Overlap Of 50% Is Recommended
Apply 2nd coat at same coverage after 4-6 hour interval. For higher thickness, additional coats may be applied. Surfaces with higher porosity may be primed with two coats of primer.
CLIENTS WE SERVED SUCCESSFULLY
